It's Alive
It's Alive
The Etch-A-Sketch is controlled by 2 stepping motors via a Fascinating
Electronic's Experimenter controller card (800) 683-KITS. It is connected
to the serial port of the Macintosh Powerbook 165. I wrote the machining
software in FutureBasic II by
Staz Software, Inc. My program reads HPGL and the old Apple 410
color plotter commands from file. The program displays the file being plotted
graphicly on screen along with the command lines from the file, controller
status and pen positioning information.
........Always busy........
Back to my Home Page. . .
and
I am not associated with any of the above companies, all trademarks belong
to them.
All information and endorsments are unsolicited.