Lil Hornet
If your here you probably read the review in Micro Flight on the Lil Hornet. It is a great ship. I stock the components here. The article infers you get the kit and all electronics for $50. This is of course just a mis-print that has been corrected in the internet version of Micro Flight.
| Item. | Description | GREAT PRICE! | PIC-LINK |
| Lil Hornet Kit |
29" span, about 10 oz. and wildly aerobatic. Comes with prop, motor and gearbox components. Retail $59.95. Photo above is of Neil Morse's (California) Lil Hornet in action.. If your tired of the floaters, heres your rock and roll! |
$50 | |
| Pixie 7 Speed Control | Up to 7 amps with BEC Very Small. | $32.00 | |
| GFS 10 | GFS 10 amp ESC, a must with the hop up 370 motor and the 8 cell pack. Comes with connectors, ready to solder to back of your motor. | $32.00 | |
| Pixie 14 Lite Speed Control | Up to 14 amps, Very small, for experienced users as soldering on the speed control is required. Lowest weight version. | $36.00 | |
| Pixie 14 Standard | Up to 14 amps, very small, has wire leads already installed. | $38.00 | |
| GWS ICS100 | Up to 5 amps with BEC. Larger than the Pixie's but a great value. | $21.00 | |
| Hornet Battery pack | 720 7 cell built to special shape for the Lil Hornet. This is the LIMIT! An 8th cell will toast the stock motor. You can use up to 6 350 Nicads but you are wasting your money in this case. Go with the 720-7! Comes without connectors. Use your own or JST below. | $24.00 | |
| Hornet Hop-up Battery Pack. | NOTE! This is for the GWS-370. 8 cell built to special shape for the Lil Hornet. Pack comes with wire ready for your connector. | $27 | |
| GWS Pico Servos | .2 oz with BB. These little 9oz torque gems are the choice servos for most micro flight applications. SPECIFY CONNECTORS. You need two for Aileron and elevator. Add a 3rd if you want rudder. I've flown them both ways and each type is fun! | $23.00 ea | |
| JST connectors | Male for battery pack, Female for charger and speed control. GWS speed control already has one female on it, Pixie has none. Specify number of males (battery) and females (speed control and charger). | $2.00 ea | |
| Carbon Tape | 1/2" wide by 6' carbon fiber tape. This is the iron on Heat-Tak, but I think it works better to put a small amount of CA or Epoxy on the surface, lay the carbon down and squeege out as much glue as possible. For strengthening front 1/3 of motor stick. May not be nessasary with motor mod below. | $3.00 | |
| Hop Up Prop! | GWS 8-4.3 prop. Great on the MM-1 Motor | $1.50 | |
| Factory Prop | Lil Hornet Factory Prop | $2.00 | |
| HOP UP MOTOR KIT
GWS 370-A |
Ready for 10 to 11 oz of thrust? Radical RC 301 motor kit. Comes with GWS 8-6 prop Run 7 or 8 720 NiMH cells. 8 cells yeilds about 6000 rpm. Need 7 amp control or better. GWS 8-6 or 9-4.7 at 6000rpm on fresh 8 cell 720. | $18.00 | |
| Extra MM-1 Motor Kit | Motor, brass tube/square/shaft/gears etc.. (This is inclued in the kit) Swings Factory or GWS 8-43 prop 5400 to 5600 RPM | $14.00 | |
| Extra Gear Set MM1 | Pinion and King gear only | $3.00 | |
| Shipping | Shipping is always just $2 from Radical RC | $2.00 | |
GWS-370 Hop Up Buyers! PLEASE NOTE! The wing location must be adjusted forward due to the higher motor and battery weight. You'll need to account for this on your own when you build the kit. Build your pushrods leaving them long on the servos side so you can finish them after final wing location is found. Lock the wing location in. It does not affect the flying abilities to make these minor changes. Lead has NO BUSINESS in a model airplane. Adjust your wing and component locations to get a lead free balance.
Bob Mosher writes:
Had a great morning with the Ltl Hornet. These guys
just can't believe
what it does in a 8 to 12 mph breeze.
OlBob, San Antonio Texas
Dave:
Just to tell you that the Lil Hornet you shipped in
late August is a great
success. I've been flying it for nearly a month and
enjoying it thoroughly.
With the 720 NiMH pack it flies for around 10 minutes,
including lots of use
of full throttle. It handles a light breeze well,
but is most fun in calm
conditions. So now I have something with which
I can practice aerobatics at
the park near home.
My Lil Hornet is a bit on the heavy side at 12 oz,
but that includes a
beefed up landing gear and rudder servo. For most
flying these are probably
not really necessary, but I like doing touch-and-goes,
as well as full stop
landings, and the rudder really makes a difference
there. Incidentally, I'm
using JR radio............
Nigel, Ottawa Ontario
Lil Hornet Motor Mod! (and other related goodies) Here is the cool mod that cuts weight and makes the motor stick less apt to break in a mishap. No, this info is not in the kit, only here at Radical RC.
Orders may be PayPal'd to davthacker@aol.com
Fax orders to 937-237-1521
Voice orders to 937-237-7889
Or email.
Yes, I do take Mastercard and Visa directly.
You may print this page, circle what you want, write in
your address / payment info and mail to:
Radical RC
7046 Harshmanville Road
Huber Heights, Ohio 45424
| RADICAL RC INDEX | BATTERIES | SERVOS | CONNECTORS |
|
|
|
|
|